AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 531

Auxiliary Equipment
Console Display/Instructions
Enter the line/trunk jack to which the maintenance alarm is connected.
3
Maintenance Alarms:
Enter maintenance alarm
line number
Delete
Backspace
Exit Enter
4 Assign or remove fhe line/trunk.
Select Enter or
Delete.
5 Return to the System Programming menu.
Select Exit two times.
Voice Messaging System and Automated
Attendant
Use this procedure to specify the touch-tone duration and the interval between
digits in codes sent between a voice messaging system and the
communications system. The touch-tone duration and interval between digit
assignment must be the same as those programmed on the voice messaging
system.
This procedure specifies the integrated voice messaging ports (line/trunk jacks)
used to connect voice messaging systems such as MERLIN MAIL Voice
Messaging System or the AUDIX Voice Power-Integrated Solution II/III
application. It also specifies the generic VMI ports (line/trunk jacks) used for
automated attendants, such as AT&T Attendant or Integrated Voice Power
Automated Attendant IS II/III.
In addition, this procedure can be used to specify the number of rings before a
call transferred by the voice messaging system is sent to the backup position
for both integrated and generic VMI ports. The number of rings cannot be
programmed for individual voice messaging systems; the single setting applies
for all. Use the Group Type procedure in '
VMI ports as either integrated or generic.
Additional Information
Dial or type:
Trunk number [ nnn ]
Slot and port number [ sspp ]
Logical ID number # [ nnn ].
(
Optional Group Features" to assign
Programming Procedures
PC
←
[ F10 ]
[ F8 ]
[ F5 ] [ F5 ]
4–181