AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 41

Programming Procedures
Using Next
When you are programming a feature that can apply to a sequence of
extensions, lines/trunks or groups, the screen key Next appears on the console
display. Next (
the next number in the sequence. You can continue to press Next until you
finish programming the entire sequence. When the last number in the sequence
displays on the screen, press Enter ( [ F10 ] or ( [ Enter ← ] on the PC) to save the final
entry and move to the next step of the procedure. Procedures that allow the use
of Next will direct you to the correct screen to continue programming as shown
in Step 6 in the example below below.
NOTE:
If you plan to take advantage of this key, remember to enter the lowest number
in the sequence at the first prompt.
Console Display/Instructions
5 Specify whether the operator receives the alert.
(QCC Operator xxxx:
Select one
– InQue Alert Enable
– InQue Alert Disable
Next
Exit
Enter
Save your entry.
6
Select Enter or
Next
Return to the System Programming menu.
7
Select two times.
Exit
on the PC) permits you to save your current entry and display
[ F9 ]
Additional Information
xxxx = operator entered in Step 1
Select InQue Alert Enable or
InQue Alert Disable.
Use Next to program the next QCC position. Go
to Step 5. The next QCC operator will be displayed
on Line 1. After programming the last QCC
operator position, select enter and go to Step 7.
PC
[ F1 ]
[ F2 ]
[ F10 ]
[ F9 ]
[ F5 ] [ F5 ]
1–21
Programming Basics