AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 402

Lines and Trunks
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Procedure: Trunks to Pools Assignment
Console Display/Instructions
1 Select the Lines and Trunks menu.
System Programming:
Make a selection
Extensions
System
Options
SysRenumber
Tables
Operator
AuxEquip
LinesTrunks
NightSrvce
Exit
2 Select Pools.
Lines and Trunks:
Make a selection
PRI
LS/GS/DSl
copy
TIE Lines
RemoteAccss
TT/1-S disC
Pools
DID
Toll Type
Exit
4-52
Programming Procedures
All loop-start trunks are assigned to the main trunk pool
(factory-set extension number 70); all tie trunks are
assigned to the trunk pool with the factory-set extension
number 891; no factory-set extensions numbers are
assigned to ground-start trunks.
Line numbers
Yes .
Yes
To program a single line/trunk:
LinesTrunks → Pools → Dial pool dial-out code → Select
entry mode → Dial no. of the line/trunk → Enter → Exit →
Exit
To program a block of lines/trunks:
LinesTrunks → Pools → Dial pool dial-out code → Select
block of lines/trunks → Toggle LED On/Off → Enter → Exit
→ Exit
To program a single line/trunk:
[ F4 ] → [ F9 ] → Type pool dial-out code → [ F10 ] → [ F6 ] → Type
no. of the line/trunk → [ F10 ] → [ F5 ] → [ F5 ]
To program a block of lines/trunks:
[ F4 ] → [ F9 ] → Type pool dial-out code → [ F10 ] → Select block
of lines/trunks → ToggIe letter R On/Off → [ F10 ] → [ F5 ] → [ F5 ]
Additional Information
>
>
PC
[ F4 ]
[ F9 ]