AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 367

System Renumbering
Single Renumbering
Use this procedure to assign a specified extension number to a telephone,
accessory, line, pool (Hybrid/PBX only), calling group, paging group, or Listed
Directory Number. Single renumbering is also used for Remote Access, Park,
Idle Line Access (Key and Behind Switch only), and Automatic Route Selection
(Hybrid/PBX only).
See Chapter 3, "Common Administrative Procedures" for detailed information.
CAUTION:
Select Exit on the console or [ F5 ] on the PC after renumbering
extensions. If you press
condition (indicated when the LED next to each DSS button is on). To
restore extensions to their normal operating state, restart the system.
When required, this procedure should be performed immediately following the
selection of a system numbering plan.
Summary: Single Renumbering
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Block Renumbering
Use this procedure to assign extension numbers to a group of extensions,
accessories, or lines. Both the original numbers and the numbers they are being
changed to must be sequentially numbered.
When required, this procedure should be performed immediately following the
selection of a system numbering plan.
Home,
extensions may remain in the forced idle
System manager
All
System idle
Form 2a, System Numbering: Extension Jacks
Form 2b, System Numbering: Digital Adjuncts
Form 2d, System Numbering: Special Renumbers
Not applicable
Old and new extension numbers
Yes
No
SysRenumber → Single → Select item → Dial old ext. no. →
Enter → Dial new ext. no. → Enter → Exit → Exit
[ F2 ] → [ F2 ] select item → Type old ext. no. → [ F10 ] → Type
new ext. no. → [ F5 ] → [ F5 ] → [ F5 ]
Programming Procedures
4-17