Programming With Spm - AT&T MERLIN LEGEND Release 3.0 System Programming Manual

Installing the SPM Software
Follow the steps below to install SPM on the PC's hard disk.
1 Switch to Drive A, if it is not already the current Drive.
A:> appears on the screen.
2 Insert the backup copy of the SPM diskette into Drive A.
Type one of the commands shown below and press
3
install
install french
install spanish
Because English is the default language, install and install english have the
same result. If you do use the language argument (english, french, or
spanish), you must type it in lowercase letters as shown. The command install
may be upper case or lower case. .
4 for the message shown below to appear.
Wait
SPM HARD DISK INSTALLATION PROGRAM
Strike a key men ready
5 Press any key to begin the installation.
When the installation is finished, the following message appears:
SPM HARD DISK INSTALLATION IS NOW COMPLETE
YOU MUST REBOOT YOUR SYSTEM BEFORE USING SPM
6 Remove the SPM diskette from Drive A and reboot your system.
The installation procedure is complete. Go to "Initializing the SPM Software. "
Initializing the SPM Software
To run correctly, the DOS version of SPM requires certain information
(transmission speed, type of monitor, and so on). You need to supply this
information only once, the first time you run SPM.
The information you provide during the initialization process is written to the
SPM configuration file (ams.cfg). If you need to change this information at some
later time, you can do so in either of the following ways:
Use any of the options in Table 2–1 to change the information in ares. cfg.
Edit the ares, cfg file. (If you are unsure about editing the file, you can
remove it. You are prompted to reinitialize the next time you invoke SPM.
The file is created at that time.)
[ Enter ↵ ]
.

Programming with SPM

2-5