AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 435

Tie Trunks
Console Display/Instructions
3 Select Inmode signaling or Outmode signaling.
TIE Trunks:
Make a selection
Direction Inmode
Intype Outmode
Dialtone
Outtype
E&M Signal AnsSupvr
Exit Disconnect
4 Specify the line(s).
**** Trunk Dial:
Enter trunk w/TouchTone
–
Lines 01-20 Entry Mode
–
Lines 21-40
–
Lines 41-6O
–
Lines 61-80
Exit
Single Line Procedure
1 Specify entry mode.
Select Entry Mode.
2 Enter the number of the line/trunk.
**** Trunk dial:
Enter Trunks w/TouchTone
Delete
Backspace
Exit Enter
3 Assign or remove touch-tone dial mode from the line/trunk.
Select Enter or
Delete.
4 Return to the System Programming menu.
Select Exit three times.
Additional Information
–
–
Select Inmode or
Outmode.
**** = option name selected in Step 3
–
For a single line, go to
Single Line Procedure.
For a block of lines, go to
Block Procedure.
**** = option name selected in Step 3
Dial or type [ nnn ].
You may continue to assign or remove
touch-tone dial mode from additional
lines/trunks by repeating Steps 2 and 3
Programming Procedures
PC
[ F6 ]
[ F7 ]
[ F6 ]
←
[ F10 ]
[ F8 ]
[ F5 ] [ F5 ] [ F5 ]
4–85