Spm Configuration File (Ams.cfg) Options - AT&T MERLIN LEGEND Release 3.0 System Programming Manual

Installing the SPM Software
NOTE:
The DEBUG attribute is also specified in ams.cfg as DEBUG=O (off), the default
setting, or DEBUG=1 (on). This attribute is used to enable the Escape-to-Shell
feature of SPM, activated by pressing [ Ctrl ] + [ F9 ]. To turn DEBUG on, you must
edit the ams.cfg file; it is not part of the initialization process. The DEBUG
attribute is for use by qualified service personnel only.
Table 2-1. SPM Configuration File (ams.cfg) Options
Option
spm -com1
spm -com2
spm -s1200
spm -s2400
spm -color
spm - mono
spm -1 english
spm -1 french
spm -1 spanish
Follow the steps below to perform the SPM initialization.
Type spm and press [ Enter ↵ ] to display the SPM Welcome screen shown in Step 2.
1
Make your entry at the C:> prompt if your PC has a hard disk.
Make your entry at the A:> prompt if you are using the floppy drive.
Press any key.
2
Welcome to SPM
The MERLIN LEGEND
System Programming
& Maintenance Utility
Please press any key
to continue
Version X.XX
The screens shown in Steps 3 through 7 appear only if the system has not been
initialized. Otherwise, the screen shown in Step 8 appears.
2-6
Programming with SPM
Use
Specifies COM1 as the serial communications port
used by SPM
Specifies COM2 as the serial communications port
used by SPM
Specifies modem speed of 1200 bps
Specifies modem speed of 2400 bps
Specifies color monitor
Specifies monochrome monitor
Specifies English as the PC language
Specifies French as the PC language
Specifies Spanish as the PC language
X.XX = current version of SPM