Did Trunks - AT&T MERLIN LEGEND Release 3.0 System Programming Manual

DID Trunks

DID Trunks
This section covers programming DID trunks and includes procedures for the
following:
Block Assignment
DID Trunk Type
Disconnect Time
Expected Digits
Delete Digits
Add Digits
Signaling
Invalid Destination
NOTE:
These procedures apply to Hybrid/PBX mode only.
Block Assignment
Use this procedure to assign each DID trunk connected to the system to either
Block 1 or Block 2.
Summary: Block Assignment
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
4-94
Programming Procedures
System manager
Hybrid/PBX
Not required
Form 3d, Incoming Trunks: DID
Block 1
Block 1, Block 2
Yes
Yes