System Programming - AT&T MERLIN LEGEND Release 3.0 System Programming Manual

System Programming

6 When the restore completes, press
Restore successful.
Please press Enter
to see the Main Menu
Sent xxxx Blocks
System Programming
A primary function of SPM is to provide a method for programming the
communications system. The Sys Program option gives you access to all of the
system programming features available from the system programming console.
Basic Programming Information
To begin programming, you must perform one of the following to display the
System Programming menu on the console or PC:
On the console:
On the PC:
In most cases, you can press Exit or [ F5 ] to exit from a screen without making
any changes. Exceptions to this are noted as part of a procedure. When you
complete a procedure and press Exit ([ F5 ]), you usually move up one screen in
the menu hierarchy. Occasionally, when you press Exit ([ F5 ]), you return to the
previous screen. In a few cases, pressing Exit brings you back to the System
Programming menu where you can select another option to program or exit from
system programming.
To complete a procedure and save the information you have programmed,
press Enter ([ F10 ]).
If you are programming a group of sequentially numbered extensions or trunks,
you may have the option of pressing Next ([ F8 ]). This saves your entry and
automatically provides the number of the next extension or trunk in the
sequence, thus saving you a couple of steps. If Next displays on the screen,
you can use it with the current option.
2-42
Programming with SPM
[ Enter ↵ ]
to return to the SPM Main Menu.
= number of blocks sent
XXXX
Menu → Sys Program → Exit
Type spm → [ Enter ] → Press any key → [ F1 ] → [ F5 ]