AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 333

Print Reports
NOTES:
1. If you select the All option, keep in mind that the reports take several
minutes to print. You may want to schedule use of the printer during
off-peak hours.
2. If you select a report for which there is no information, the report header
still prints.
3. Print reports if you cannot back up your system programming information.
4. Do not print reports if your system must handle more than 100 calls per
hour.
5. If you are printing from the console, your printer must be connected to
the SMDR port. If you are programming on a PC with SPM, you have the
following choices:
Print reports on the SMDR printer (if available).
Print reports on the PC printer.
Save reports (on hard disk or floppy).
View reports (browse).
See Chapter 2, "Programming With SPM, " for details.
Summary: Printing System Reports
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
System manager
All
Not required
Not applicable
Not applicable
Any saved report
No
No
To print trunk information:
More → Print → Trunk Info → Select trunk type → Exit
To print extension information:
More → Print → More → Ext Info → Dial extension number
→ Enter → Exit
To print all other reports:
More → Print → Select report → Exit
Common Administrative Procedures
3–211