AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 560

Optional Group Calling Features
Console Procedure Extensions → More → Grp Calling → Hunt Type → Dial
PC Procedure
Group Calling Delay Announcement
Use this procedure to designate the announcement device used to play
messages to callers while they are waiting in the queue.
Only one announcement device can be designated for each calling group;
however, more than one calling group can use the same announcement device.
The extension to which the delay announcement device is connected should not
be programmed as a calling group member.
If the extension jack or MFM was previously programmed as a regular
extension, you must remove all line/trunk button assignments before you
designate the extension jack as a delay announcement device.
Summary: Group Calling Delay Announcement
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
4-210
Programming Procedures
calling group ext. no. → Enter → Circular or Linear →
Enter → Exit → Exit → Exit
[ F6 ] → [ PgUp ] → [ F4 ] → [ F1 ] → Type calling group ext. no. → [ F10 ]
→ [ F1 ] or [ F2 ] → [ F10 ] → [ F5 ] → [ F5 ]
System manager
All
Not required
Form 7d, Group Calling
No delay announcement devices are assigned .
Announcement, No announcement
No
No
Extensions → More → Grp Calling → DelayAnnce → Dial
calling group ext. no. → Enter → Dial ext. no. of
announcement device → Enter → Exit → Exit
[ F6 ] → [ PgUp ] → [ F4 ] → [ F2 ] → Type calling group ext. no. → [ F10 ]
→ Type ext. no. of announcement device → [ F10 ] → [ F5 ] →
[ F5 ]