AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 446

DID Trunks
ConsoleDisplay/Instructions
4 Enter the trunk block ( n = 1 or 2 ).
DID Block Assignment:
Enter the block number
(1-2)
Backspace
Enter
Exit
5 Save your entry.
Select Enter.
6 Specify the line(s).
Direct Inward Dialing:
Assign lines to blocks
Lines 01-20 Entry Mode
– Lines 21-40
Lines 41-60
–
61-80
– Lines
Exit
Single Line Procedure
1
Specify entry mode.
Select Entry Mode.
2 Enter the trunk number.
Block x:
Enter line/trunk number
Delete
Next
Backspace
Exit Enter
3 Assignor remove the trunk.
Select Enter or
Delete.
4 Continue to enter trunks for the other trunk block or go to Step 5.
Select Next.
4-96
Programming Procedures
Additional Information
Dial or type [n].
For a single line, go to
Single Line Procedure
–
For a block of lines, go to
Block Procedure.
x = block entered in Step 4
Dial or type [ nnn ].
You may continue to assignor remove
DID trunks from the block by repeating
Steps 2 and 3.
Return to Step 2. The block will be
displayed on Line 1.
PC
←
[ F10 ]
[ F6 ]
←
[ F10 ]
[ F8 ]
[ F9 ]