Programming Mlx Display Telephones Using The Display - AT&T MERLIN LEGEND Release 3.0 System Programming Manual

General Feature Use and Telephone Programming
Table D-4. Programming MLX Display Telephones Using the Display
Step
1 Label the button to be
programmed.
Note: Skip this step if the feature
will not be programmed onto a
button.
2 Begin programming.
3 Identify the button to be
programmed.
To delete the feature currently
programmed on the button:
D–12
System Programming
Action
Remove the clear label cover from the
telephone by pulling up on the tab that
extends from the top of the cover.
Write the feature name on the card next to
the button to be programmed.
Replace the cover.
Press Menu.
Select Ext Program from the display.
Select Start from the display.
Press the button you labeled.
Note: If the feature does not get
programmed onto a button, press any line
button. This does not affect the button in
any way.
The display identifies the feature currently
programmed on the button. If no feature is
programmed, the display indicates that
the button is blank.
Select Delete from the display. The button
is now blank.
Press the button you labeled again to
continue programming.
Note: If the currently programmed feature
was not deleted from the button, the new
feature programmed onto it will replace it.
Continued on next page