AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 420

DS1 Facilities
Line Compensation
Use this procedure to specify the amount of cable loss in decibels. Cable loss is
based on the length of cable between the 100D module and the Channel
Service Unit, as shown below:
1 = 0.6 dB loss
2 = 1.2 dB loss
3 = 1.8 dB loss
4 = 2.4 dB loss
5 = 3.0 dB loss
Summary: Line Compensation
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Procedure: Line Compensation
Console Display/Instructions
1 Select the Lines and Trunks menu.
System Programming:
Make a selection
Extensions
System
Options
SysRenumber
Tables
Operator
LinesTrunks AuxEquip
NightSrvce
Exit
4–70
Programming Procedures
System manager
All
100D module idle
Form 3b, Incoming Trunks: DS1 Connectivity
(100D module)
1 (0.6 dB loss)
1 t o 5
No
No
LinesTrunks → LS/GS/DS1 → Dial slot no. → Enter → Line
Comp → Drop → Dial line compensation value → Enter →
Exit → Exit
[ F4 ] → [ F1 ] → Type slot no. → [ F10 ] → [ F6 ] → [ Alt ] + [ P ] → Type
line compensation value → [ F10 ] → [ F5 ] → [ F5 ]
Additional Information
>
PC
[ F4 ]