AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 462

PRI Facilities
Telephone Number
Use this procedure to assign a string of up to 12 digits to each PRI channel.
This string must match the number sent by the network (that is, the number
provided by the PRI service provider) to indicate the number dialed by an
outside caller. The system uses this number to route the call to the correct
destination, which means that the number assigned to each channel in the
same B-channel group must be unique. Note also that the number cannot be
the same as the associated test telephone number.
Summary: Telephone Number
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Procedure: Telephone Number
Console Display/Instructions
1 Select the Lines and Trunks menu.
System Programming:
Make a selection
System Extensions
Options
SysRenumber
Tables
Operator
AuxEquip
LinesTrunks
NightSrvce
Exit
4–112
Programming Procedures
System manager
Hybrid/PBX, Key
Not required
Form 3b, Incoming Trunks: DS1 Connectivity
(100D module)
No digits
Up to 12 digits (any combination of O to 9)
No
No
LinesTrunks → PRI → PhoneNumber → Dial trunk no. → Enter
→ Drop → Dial telephone no. → Enter → Exit → Exit
[ F4 ] → [ F6 ] → [ F1 ] → Type trunk no. → [ F10 ] → [ Alt ] + [ P ] → Type
telephone no. → [ F10 ] → [ F5 ] → [ F5 ]
Additional Information
>
PC
[ F4 ]