AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 147

System Operator Positions
Console Display/Instructions
3 Select Direct-Line Console (DLC).
System Operator:
Make a selection
Direct Line
Queued Call
Exit
4 Specify the DLC extension.
DLC Operator Positions
Enter extension
Store All Delete
Backspace
Enter
Exit
Assign or remove the DLC operator extension.
5
Select Enter or
Delete.
6 Indicate that you have finished entering all positions.
Select Store All.
Additional Information
If you get the System Busy message, wait
for an idle condition or exit system
programming and try again later.
If no DSS is attached:
SP:
"(Entering an Extension"
If DSS is attached:
Toggle the red LED on or
off as required. Go to Step 6.
On = extension is currently assigned
as a DLC position.
Flashing = extension can be assigned
as a DLC position.
Off = extension cannot be assigned
as a DLC position.
You may continue to assign or remove
DLC operator positions by repeating
Steps 4 and 5.
The session is terminated, and the system
restarts. You must enter system
programming again to continue.
Common Administrative Procedures
PC
[ F1 ]
←
[ F10 ]
[ F8 ]
[ F3 ]
3–25