AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 405

Lines and Trunks
4. If you are copying assignments to a block of lines/trunks and one of the lines
or trunks is in use, you see the message Trunk Busy - Pls wait on your
display. The copying for the rest of the lines/trunks in the block is delayed
until the busy line/trunk becomes idle. If you exit without waiting for the
copying to complete, the copying done up to that point is not canceled.
Summary: Copy Options for Lines/Trunks
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure To copy individual lines/trunks:
PC Procedure
System manager
All (but note differences)
Not required
Form 2c, System Numbering: Line/Trunk Jacks
Form 3c, Incoming Trunks: TIE
Form 3d, Incoming Trunks: DID
Not applicable
Not applicable
No
Not applicable
LinesTrunks → Copy → Single → Dial copy from trunk no. →
Enter → Dial copy to trunk no. → Enter → Exit → Exit →
Exit
To copy blocks of lines/trunks:
LinesTrunks → Copy → Block → Dial copy from trunk no. →
Enter → Dial first copy to trunk no. in block → Enter → Dial
last copy to trunk no. in block → Enter → Exit → Exit →
Exit
To copy individual lines/trunks:
[ F4 ] → [ F7 ] → [ F1 ] → Type copy to trunk no. → [ F10 ] → Type
copy from trunk no. → [ F10 ] → [ F5 ] → [ F5 ] → [ F5 ]
To copy blocks of lines/trunks:
[ F4 ] → [ F7 ] → [ F2 ] → Type copy from trunk no. Type first
copy to trunk no. in block → [ F10 ] → [ F5 ] → Type last copy to
trunk no. in block → [ F10 ] → [ F5 ] → [ F5 ] → [ F5 ]
Programming Procedures
4–55