AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 634

Night Service
NOTE:
For Release 2.1 and earlier, after setting Start and Stop time for Night Service
the current day of the week for Night Service must be set using the following
procedure.
NightSrvce → Day of Week → Dial the current day of the week →
Enter → Exit
If system programming information is being loaded into memory from a backup
diskette, the current day of the week must be reset.
Night Service can be turned off by using the following procedure:
NightSrvce → Day of Week → Dial 9 → Enter → Exit
NOTE:
The current day of the week for Night Service must be reset if system
programming information is being loaded into memory from a backup.
Summary: Night Service with Time Set
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
4-284
Programming Procedures
System manager
All
Not required
Form 9c, Night Service: Time Set
Not applicable
Day: 0 to 6; Time: 0000 to 2359
No
No
To add or change start/stop time:
NightSrvce → Start → Drop → Dial start day and time →
Enter → Stop → Drop → Dial stop day and time → Enter →
Exit
To activate/deactivate:
NightSrvce → Time Control → Of f or On → Enter → Exit
To add or change start/stop time:
[ F10 ] → [ F6 ] → [ Alt ] + [ P ] → Type start day and time → [ F10 ] →
[ F7 ] → [ Alt ] + [ P ] → Type stop day and time → [ F10 ] → [ F5 ]
To activate/deactivate:
[ F10 ] → [ F8 ] → [ F1 ] or [ F2 ] → [ F10 ] → [ F5 ]