Ipv6 Ospf Priority - Dell Networking 7048 Reference Manual

Example
The following example changes the default OSPF network type to point-to-
point.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf network point-to-
point

ipv6 ospf priority

Use the ipv6 ospf priority command in Interface Configuration mode to set
the OSPF priority for the specified router interface. Use the no form of the
command to return the priority to the default value.
Syntax
ipv6 ospf priority
no ipv6 ospf priority
number-value
•
interface. (Range: 0–255) A value of 0 indicates that the router is not
eligible to become the designated router on this network.
Default Configuration
1, the highest router priority, is the default value.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF priority at 50 for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf priority 50
1264
OSPFv3 Commands
number-value
— Specifies the OSPF priority for the specified router