Max-Response-Failure - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

max-response-failure

max-response-failure maxFailureValue
Syntax
no max-response-failure
Command introduced before JUNOSe Release 7.1.0.
Release Information
Terminates a test when the maxFailureValue is reached. That is, when there is no
Description
response to a designated number of operation requests, the test is terminated. This
feature applies only to pathEcho entries. The no version restores the default value,
five consecutive failures.
Options
RTR Configuration
Mode
1282
max-response-failure
maxFailureValue Number of operation requests not responded to; 0 turns this
feature off; default value is 5