Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual page 1480

Software for e series broadband services routers command reference a to m
Table of Contents

Advertisement

JUNOSe 11.0.x Command Reference Guide A to M
mpls-relay atm cell-packing mcpt-timer............1378
mpls-relay atm vpi-range vci-range...................1379
mpls-relay disable.............................................1380
See also LDP commands, MPLS (IS-IS) commands,
MPLS (OSPF) commands, RSVP-TE commands
MPLS commands (IS-IS)
mpls spf-use-any-best-path...............................1398
mpls traffic-eng.................................................1405
mpls traffic-eng router-id..................................1413
MPLS commands (OSPF)
mpls traffic-eng area.........................................1407
mpls traffic-eng multicast-intact........................1412
mpls traffic-eng router-id..................................1413
Multicast command
mroute port admission-bandwidth-limit............1416
mroute port limit..............................................1417
Multilink Frame Relay commands. See MLFR
commands
multilink frame relay interface.......................................8
multilink PPP interface...................................................9
N
NAT commands
baseline ip nat....................................................239
clear ip nat translation........................................391
ip nat..................................................................853
ip nat inside source list.......................................854
ip nat inside source static....................................855
ip nat outside source list.....................................856
ip nat outside source static..................................857
ip nat pool..........................................................858
ip nat translation.................................................859
ip nat translation max-entries.............................860
license nat........................................................1201
NFS commands
host....................................................................673
ip nfs..................................................................861
ip nfs host...........................................................862
no commands vs. default commands.............................3
non-PPP equal access commands
baseline ip dhcp-local..........................................232
baseline ipv6 dhcpv6-local..................................246
default-router .....................................................502
dns-server ..........................................................532
domain-name.....................................................541
ip dhcp-local excluded-address...........................756
ip dhcp-local limit...............................................757
ip dhcp-local pool................................................758
ip dhcp-local unique-client-ids.............................760
lease ................................................................1193
notice icons.............................................................xxxix
NTP commands
clock set..............................................................435
clock summer-time date.....................................437
1438
Index
clock summer-time recurring..............................438
clock timezone....................................................439
null interface..................................................................9
NVS commands
check-disk...........................................................353
flash-disk compare..............................................613
flash-disk duplicate.............................................614
flash-disk initialize..............................................615
flash-disk scan....................................................616
mount...............................................................1316
O
OCx/STMx commands
baseline path interface sonet..............................260
baseline section interface sonet..........................266
clock source........................................................436
controller sonet...................................................460
loopback...........................................................1237
OSPF commands
address area.........................................................86
address authentication message-digest.................89
address authentication-key...................................88
address authentication-none.................................91
address cost..........................................................93
address dead-interval............................................94
address hello-interval............................................97
address message-digest-key md5..........................98
address network...................................................99
address passive-interface....................................100
address priority...................................................102
address retransmit-interval.................................104
address transmit-delay........................................106
area default-cost.................................................127
area nssa............................................................130
area range...........................................................131
area stub.............................................................132
area virtual-link...................................................133
area virtual-link authentication-key.....................134
area virtual-link authentication-none...................136
area virtual-link dead-interval..............................137
area virtual-link hello-interval..............................138
area virtual-link message-digest-key md5...........139
area virtual-link retransmit-interval.....................140
area virtual-link transmit-delay...........................141
area virtual-linkauthentication
message-digest................................................135
area.
no area See Command Reference Guide N
to Z, OSPF commands
authentication message-digest............................197
authentication-key..............................................196
authentication-none............................................199
auto-cost reference-bandwidth............................206
automatic-virtual-link..........................................207
baseline ip ospf...................................................240

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.0

Table of Contents