Mpls Atm Vci Range - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

mpls atm vci range

mpls atm vci range minVCI maxVCI
Syntax
no mpls atm vci range
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the range for virtual circuit identifiers that can be used in MPLS labels for
Description
an MPLS major interface on an ATM AAL5 interface using the interface label space.
Creates the MPLS major interface if it does not yet exist. An error message is
generated if you issue the command for any other layer 2 interface, as they do not
support the interface label space. The no version deletes the range.
Options
Interface Configuration
Mode
minVCI Lowest virtual circuit identifier acceptable for a label, a value from
33–65535
maxVCI Highest virtual circuit identifier acceptable for a label, a value from
33–65535
Chapter 13: M Commands
1319
mpls atm vci range