Mpls-Relay Atm Vpi-Range Vci-Range - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

mpls-relay atm vpi-range vci-range

[ no ] mpls-relay atm vpi-range vpiStart vpiEnd vci-range vciStart vciEnd
Syntax
Command introduced in JUNOSe Release 10.2.0.
Release Information
Configures a single virtual path identifier (VPI)/virtual circuit identifier (VCI) range of
Description
ATM VCs whose cells need to be transported on the single pseudowire. You can
configure this command on the ATM port only after you associated a pseudowire
with the port by using the mpls-relay or route interface tunnel command. When
you run the mpls-relay or route interface tunnel command, no default VPI/VCI
range is configured. You must specifically configure the VPI/VCI ranges. You can use
this command only on an ATM port (ATM AAL5 over ATM major interface). The
VPI/VCI values that are not part of the specified range can be used for other existing
applications. The no version removes the configured VPI/VCI range.
NOTE: The total number of VCs configured with the mpls-relay atm vpi-range
vci-range command cannot exceed the maximum ATM VC capacity of the line
module you are using. For details about the ATM VC capacity of supported line
modules, see JUNOSe Release Notes, Appendix A, System Maximums.
Options
Interface Configuration
Mode
Related Topics
atm Configures ATM interface parameters for MPLS cross-connect. A local
cross-connect enables the router to function as a layer 2 switch. It operates with
any supported layer 2 service
vpiStart Starting virtual path identifier (inclusive) of the VC subrange you are
configuring; number in the range 0–255
vpiEnd Ending virtual path identifier (inclusive) of the VC subrange you are
configuring; number in the range 0–255
vciStart Starting virtual circuit identifier (inclusive) of the VC subrange you are
configuring; number in the range 1–65535
vciEnd Ending virtual circuit identifier (inclusive) of the VC subrange you are
configuring; number in the range 1–65535
Multiple ATM Virtual Circuits over a Single Pseudowire Overview and Multiple ATM
Virtual Circuits over a Single Pseudowire Example in the JUNOSe BGP and MPLS
Configuration Guide
Chapter 13: M Commands
mpls-relay atm vpi-range vci-range
1379