Ipv6 Prefix-List - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

ipv6 prefix-list

ipv6 prefix-list listName { description desc | { [ seq sequence ] { permit | deny }
Syntax
ipv6Prefix [ ge geNumber ] [ le leNumber ] } }
no ipv6 prefix-list listName [ description | [ seq sequence ] [ { permit | deny }
ipv6Prefix [ ge geNumber ] [ le leNumber ] ] ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Creates an IPv6 prefix list for route filtering; specifies a list entry a permit or deny
Description
clause for a network address. The no version removes the specified prefix list or the
specified list entry.
Options
Global Configuration
Mode
listName Name of the IPv6 prefix list; a string of up to 32 characters
desc Description of the prefix list
sequence Number in the range 0–65535 that indicates the position the prefix
list entry has in the already existing list of entries for the prefix list; if you do not
specify a sequence, the command uses the value of the last sequence number +
5
permit When specified, the router redistributes any prefix that matches the
filtered route based on the set actions
deny When specified, the router drops any prefix that matches the filtered
route
ipv6Prefix Network route that you want to filter, in the format ipv6Address /
length, where
ipv6Address—Base IPv6 address of the network route that you want to filter
(for example, ::ffff:a:b:c:d)
length Length of the network prefix; number of bits masking base address
to produce address to be matched
geNumber Route being filtered matches if its prefix is within the range specified:
greater than or equal to geNumber and less than or equal to 32
leNumber Route being filtered matches if its prefix is within the range specified:
greater than or equal to length and less than or equal to leNumber
Chapter 10: I Commands
1089
ipv6 prefix-list