Configuring Per-Port Power Management - Cisco WS-C6506 Software Manual

Chapter 55 Configuring a VoIP Network
Table 55-3 Voice-Related CLI Command Module and Platform Support (continued)
CLI Commands
show environment power
Voice-related commands
set port auxiliaryvlan
show port auxiliaryvlan
set port voice interface
show port voice interface
show port voice
show port voice fdl
show port voice active
QoS commands related to voice
set port qos mod/port cos-ext
set port qos mod/port trust-ext
show port qos
1. Ethernet Module = Ethernet switching module with voice daughter card.
2. WS-X6608-T1 and WS-X6608-E1 = 8-port T1/E1 ISDN PRI modules.
3. WS-X6624-FXS = 24-port FXS analog station interface module.
4. X = Command supported on Catalyst 6500 series switch only; XX = Command supported on Catalyst 4500 series, 5000 family, and
6500 series switches. All modules that are listed in

Configuring Per-Port Power Management

This section describes the per-port power management and the CLI commands that are used to configure
power management for IP phones.
Note To determine the exact power requirements for your configuration to ensure that you are within the
system power budget, see the
This section applies to the Ethernet switching modules with the voice daughter card only. For
Note
information on powering the IP phones that are connected to the other Ethernet switching modules, refer
to the Catalyst Family Inline-Power Patch Panel Installation Note publication.
For each IP phone that is connected to an Ethernet switching module with a voice daughter card installed,
the module allocates part of the available system power to power up and run the phone. You can apply
the power on an individual port basis.
Only one IP phone can be powered per port; the phone must be connected directly to the switch port. If
a second phone is daisy chained off the phone that is connected to the switch port, the second phone
cannot be powered by the switch.
OL-8978-04
1
Ethernet Module
X
X/X
X/X
X
X
X/X
X/X
Table 55-3 are supported only on Catalyst 6500 series switches.
"Generating a System Status Report" section on page
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
2
WS-X6608-T1/E1 WS-X6624-FXS
X X
X X
X X
X X
X
X X
Configuring VoIP on a Switch
3
22-17.
55-11