Configuring Rsvp Support - Cisco WS-C6506 Software Manual

Chapter 52 Configuring QoS
Enter the parameters as a number of seconds in the range from 0–65535. The value of the initial
parameter plus the value of the increment parameter must not exceed the value of the maximum
parameter.
This example shows how to configure the parameters that COPS uses to communicate with the PDP
server:
Console> (enable) set cops retry-interval 15 1 30
Connection retry intervals set.
Console> (enable)

Configuring RSVP Support

Note •
•
These sections describe how to configure the RSVP null service template and receiver proxy
functionality support:
•
•
•
•
•
•
•
•
Enabling RSVP Support
To enable RSVP support, perform this task in privileged mode:
Task
Step 1 Enable RSVP support on the switch.
Step 2 Verify the configuration.
Step 3 Display RSVP activity.
This example shows how to enable RSVP support:
Console> (enable) set qos rsvp enable
RSVP enabled on the switch.
Console> (enable)
OL-8978-04
Supervisor Engine 1 with a Layer 2 Switching Engine does not support the commands in this
section.
Throughout this publication and all Catalyst 6500 series switch publications, the term RSVP refers
to the RSVP null service template and receiver proxy functionality support as implemented on the
Catalyst 6500 series switches.
Enabling RSVP Support, page 52-85
Disabling RSVP Support, page 52-86
Enabling the Participation in the DSBM Election, page 52-86
Disabling the Participation in the DSBM Election, page 52-86
Configuring the Policy Decision Point Servers, page 52-87
Deleting the PDP Server Configuration, page 52-87
Configuring the RSVP Policy Timeout, page 52-88
Configuring the RSVP Use of Local Policy, page 52-88
Command
set qos rsvp {enable | disable}
show qos rsvp info
show qos rsvp flow-info
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring QoS on the Switch
52-85