valid igmp leaves received
valid igmp queries received
igmp gs queries transmitted
igmp leaves transmitted
failures to add GDA to EARL
topology notifications received 10
number of CGMP packets dropped
Configuring RGMP on the Switch
RGMP is disabled by default. Use the following command to enable RGMP globally:
Coriolis> (enable) set rgmp enable
RGMP enabled.
Disabling RGMP on the Switch
To disable RGMP, use the following command:
Coriolis> (enable) set rgmp disable
RGMP disabled.
Configuring RGMP on the Router
RGMP must be enabled on each interface that has the appropriate topology. Use this command:
Router(config)# vlan−interface 3
Router(config−if)# ip rgmp
Disabling RGMP on the Router
To disable RGMP, use the following command:
Router(config)# vlan−interface 3
Router(config−if)# no ip rgmp
Note Here are some related commands that you can try on the router:
debug ip rgmp [group_name | group_address]
show ip rgmp interface [interface_unit_name]
show ip rgmp groups [group_name | group_address]
Displaying RGMP Groups
To display all the multicast groups that were joined by RGMP−capable routers, use the following command:
Coriolis> (enable) show rgmp group
VlanDest MAC/Route DesRGMP Joined Router Ports
————————————————————————————————————————————————
201−00−5e−46−85−111/1,2/14
101−00−5e−14−11−285/1
Total Number of Entries = 2
'*' − Configured
0
568
0
0
0
2456875
155