Clearing Multicast Router Ports; Clearing Multicast Group Entries - Cisco WS-C4003 - Catalyst 4000 Chassis Switch Software Configuration Manual

Chapter 15 Configuring Multicast Services
This example shows how to define multicast groups manually and verify the configuration (the asterisks
indicate the entry was manually configured):
Console> (enable) set cam static 01-00-11-22-33-44 2/6-12
Static multicast entry added to CAM table.
Console> (enable) set cam static 01-11-22-33-44-55 2/6-12
Static multicast entry added to CAM table.
Console> (enable) set cam static 01-22-33-44-55-66 2/6-12
Static multicast entry added to CAM table.
Console> (enable) set cam static 01-33-44-55-66-77 2/6-12
Static multicast entry added to CAM table.
Console> (enable) show multicast group
CGMP enabled
IGMP disabled
VLAN
----
1
1
1
1
Total Number of Entries = 4
Console> (enable)

Clearing Multicast Router Ports

To clear manually configured multicast router ports, perform one of these tasks in privileged mode:
Task
Disable specific manually configured multicast
router ports.
Disable all manually configured multicast router
ports.
This example shows how to clear a manually configured multicast router port entry:
Console> (enable) clear multicast router 2/12
Port 2/12 cleared from multicast router port list.
Console> (enable)

Clearing Multicast Group Entries

To disable manually configured multicast group entries, perform this task in privileged mode:
Task
Clear a multicast group entry from the CAM table. clear cam mac_addr [vlan]
This example shows how to clear a multicast group entry from the CAM table:
Console> (enable) clear cam 01-11-22-33-44-55 1
CAM entry cleared.
Console> (enable)
78-12647-02
Dest MAC/Route Des Destination Ports or VCs / [Protocol Type]
------------------ ----------------------------------------------------
01-00-11-22-33-44* 2/6-12
01-11-22-33-44-55* 2/6-12
01-22-33-44-55-66* 2/6-12
01-33-44-55-66-77* 2/6-12
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
Configuring Multicast Router Ports and Group Entries
Command
clear multicast router mod_num/port_num
clear multicast router all
Command
15-17