Setting The Basic Port Configuration - Cisco SF 300-08 Administration Manual

Port Management

Setting the Basic Port Configuration

Setting the Basic Port Configuration
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco Small Business 300 Series Managed Switch Administration Guide
7. If PoE is supported and enabled for the switch, configure the switch as
described in Managing Power-over-Ethernet
The Port Settings Page displays the global and per port setting of all the ports.
This page enables you to select and configure the desired ports from the Edit Port
Setting Page.
SFP Fiber takes precedence when both ports are being used.
To configure port settings:
Click Port Management > Port Settings. The Port Settings Page opens.
Select (Jumbo Frames) Enable to support packets of up to 10 Kb in size. If Jumbo
Frames is not enabled, the system supports packet size up to 1,632 bytes.
Click Apply to update the global setting.
Jumbo frames configuration changes take effect only after the Running
Configuration is explicitly saved to the Startup Configuration File using the Copy/
Save Configuration Page, and the switch is rebooted.
To update the port settings, select the desired port, and click Edit. The Edit Port
Setting Page opens.
Modify the following parameters:
• Port—Select the port number.
• Port Description—Enter the port user-defined name or comment.
• Port Type—Displays the port type. The possible options are:
- Copper Ports—Regular, not combo, support the following values: 10M,
100M, 1000M (type: Copper).
- Combo Ports Copper—Combo port connected with copper CAT5
cable, supports the following values: 10M, 100M, 1000M (type: ComboC).
- Combo Fiber—SFP Fiber Gigabit Interface Converter Port with the
following values: 100M and 1000M (type: ComboF)
• Administrative Status—Select whether the port should be operational (Up)
or non-operational (Down) when the switch is rebooted.
Devices.
9
87