Setting The System Contact And Location - Cisco WS-C2950SX-48-SI Configuration Manual

Chapter 27 Administering the Switch
This example shows how to set the system prompt for the switch:
Console> (enable) set prompt Catalyst4012>
Catalyst4012> (enable)
Clearing the System Name
To clear the system name, perform this task in privileged mode:
Task
Clear the system name.
This example shows how to clear the system name:
Console> (enable) set system name
System name cleared.
Console> (enable)

Setting the System Contact and Location

You can set the contact name and location to help you with resource management tasks. To set the system
contact and location, perform this task in privileged mode:
Task
Step 1 Set the system contact.
Step 2 Set the system location.
Step 3
Verify the global system information.
This example shows how to set the system contact to sysadmin@corp.com and location to
Sunnyvale, CA:
Console> (enable) set system contact sysadmin@corp.com
System contact set.
Console> (enable) set system location Sunnyvale CA
System location set.
This example shows how to verify the configuration:
Console> (enable) show system
PS1-Status PS2-Status PS3-Status PEM Installed PEM Powered
---------- ---------- ---------- ------------- -----------
ok
Fan-Status Temp-Alarm Sys-Status Uptime d,h:m:s Logout
---------- ---------- ---------- -------------- ---------
ok
PS1-Type
----------------- ----------------- -----------------
WS-X4008-DC-650W
Modem
------- ----- ------- ---- -------------------------
78-15486-01
ok ok
off ok
PS2-Type
WS-X4008
Baud Traffic Peak Peak-Time
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2980G Switches Software Configuration Guide
Command
set system name
Command
set system contact [contact_string]
set system location [location_string]
show system
yes no
0,18:24:41 none
PS3-Type
WS-X4008
Setting the System Contact and Location
—
Release 8.1
27-3