Re-executing the Configuration Commands in the Startup Configuration File
Device#
copy tftp:switch-config usbflash0:new-config
Re-executing the Configuration Commands in the Startup Configuration File
To re-execute the commands located in the startup configuration file, complete the task in this section:
Procedure
Step 1
Step 2
Clearing the Startup Configuration
You can clear the configuration information from the startup configuration. If you reboot the device with no
startup configuration, the device enters the Setup command facility so that you can configure the device from
scratch. To clear the contents of your startup configuration, complete the task in this section:
Procedure
Step 1
Step 2
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
236
Command or Action
enable
Example:
Device> enable
configure memory
Example:
Device# configure memory
Command or Action
enable
Example:
Device> enable
erase nvram
Example:
Managing Configuration Files
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Re-executes the configuration commands
located in the startup configuration file.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Clears the contents of your startup
configuration.