Displaying Ip Multicast Information - Cisco WS-C6506 Software Manual

Configuring CEF for PFC2/PFC3A on the Switch
To configure the IP MMLS threshold, perform this task:
Task
Configure the IP MMLS threshold.
This example shows how to configure the IP MMLS threshold to 10 packets per second:
Router(config)# mls ip multicast threshold 10
Router(config)#
Use the no keyword to deconfigure the threshold.
Enabling IP MMLS on MSFC2/MSFC3 Interfaces
IP MMLS is enabled by default on the MSFC2/MSFC3 interface when you enable IP PIM on the
interface. Perform this task only if you disabled IP MMLS on the interface and you want to reenable it.
Note You must enable IP PIM on all participating MSFC2/MSFC3 interfaces before IP MMLS will function.
For information on configuring IP PIM on MSFC2/MSFC3 interfaces, see the
MSFC2/MSFC3 Interface" section on page
To enable IP MMLS on an MSFC2/MSFC3 interface, perform this task:
Task
Enable IP MMLS on an MSFC2/MSFC3
interface.
This example shows how to enable IP MMLS on an MSFC2/MSFC3 interface:
Router(config-if)# mls ip multicast
Router(config-if)#
Use the no keyword to disable IP MMLS on an MSFC2/MSFC3 interface.

Displaying IP Multicast Information

These sections describe how to display IP multicast information:
•
•
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
13-20
Displaying IP Multicast Information on MSFC2/MSFC3, page 13-21
Displaying the IP Multicast Information on the Supervisor Engine, page 13-24
Chapter 13
Command
Router(config)# [no] mls ip multicast threshold ppsec
13-19.
Command
Router(config-if)# [no] mls ip multicast
Configuring CEF for PFC2 and PFC3A
"Enabling IP PIM on an
OL-8978-04