Configuring Appletalk Intervlan Routing On The Msfc - Cisco WS-C6506 Software Manual

Configuring InterVLAN Routing on the MSFC
To configure interVLAN routing for Internetwork Packet Exchange (IPX), perform this task:
Task
Step 1 (Optional) Enable IPX routing on the router
Step 2
(Optional) Specify an IPX routing protocol
Step 3
Specify a VLAN interface on the MSFC.
Step 4
Assign a network number to the VLAN
Step 5 Exit configuration mode.
1. This step is necessary if you have multiple routers in the network.
2. This step is necessary if you enabled IPX routing in Step 1. This step might include other commands, such as using the network router
configuration command to specify the networks to route. Refer to the documentation for your router platform for detailed information on
configuring routing protocols.
3. This step enables IPX routing on the VLAN. When you enable IPX routing on the VLAN, you can also specify an encapsulation type.
This example shows how to enable IPX routing on the MSFC, create a VLAN interface, and assign an
IPX network address to the interface:
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# ipx routing
Router(config)# ipx router rip
Router(config-ipx-router)# network all
Router(config-ipx-router)# interface vlan100
Router(config-if)# ipx network 100 encapsulation snap
Router(config-if)# ^Z
Router#

Configuring AppleTalk InterVLAN Routing on the MSFC

To configure interVLAN routing for AppleTalk, perform this task:
Task
Step 1 (Optional) Enable AppleTalk routing on
the router
Step 2
Specify a VLAN interface on the MSFC. Router(config)# interface vlan-id
Step 3
Assign a cable range to the VLAN.
Step 4
Assign a zone name to the VLAN.
Step 5
Exit configuration mode.
1.
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
12-4
3
.
1
.
This step is necessary if you have multiple routers in the network.
Command
1
. Router(config)# ipx routing
2
. Router(config)# ipx router ipx_routing_protocol
Router(config)# interface vlan-id
Router(config-if)# ipx network [network | unnumbered]
encapsulation encapsulation-type
Router(config-if)# Ctrl-Z
End with CNTL/Z.
Command
Router(config)# appletalk routing
Router(config-if)# appletalk cable-range cable-range
Router(config-if)# appletalk zone zone-name
Router(config-if)# Ctrl-Z
Chapter 12 Configuring InterVLAN Routing
OL-8978-04