Enabling Vtp Version 2 - Cisco 2950 - Catalyst Switch Configuration Manual

Chapter 18 Configuring VTP
Note You can also configure VTP transparent mode by using the vlan database privileged EXEC command
to enter VLAN configuration mode and by entering the vtp transparent command, similar to the second
procedure under the
VLAN configuration command to return the switch to VTP server mode. If extended-range VLANs are
configured on the switch, you cannot change VTP mode to server. You receive an error message, and the
configuration is not allowed.

Enabling VTP Version 2

VTP version 2 is disabled by default on VTP version 2-capable switches. When you enable VTP
version 2 on a switch, every VTP version 2-capable switch in the VTP domain enables version 2. You
can only configure the version on switches in VTP server or transparent mode.
VTP version 1 and VTP version 2 are not interoperable on switches in the same VTP domain. Every
Caution
switch in the VTP domain must use the same VTP version. Do not enable VTP version 2 unless every
switch in the VTP domain supports version 2.
In TrCRF and TrBRF Token ring environments, you must enable VTP version 2 for Token Ring VLAN
Note
switching to function properly. For Token Ring and Token Ring-Net media, VTP version 2 must be
disabled.
For more information on VTP version configuration guidelines, see the
page
Beginning in privileged EXEC mode, follow these steps to enable VTP version 2:
Command
Step 1
configure terminal
Step 2 vtp version 2
Step 3
end
Step 4
show vtp status
To disable VTP version 2, use the no vtp version global configuration command.
You can also enable VTP version 2 by using the vlan database privileged EXEC command to enter
Note
VLAN configuration mode and entering the vtp v2-mode VLAN configuration command. To disable
VTP version 2, use the no vtp v2-mode VLAN configuration command.
78-11380-10
"Configuring a VTP Server" section on page
18-9.
Purpose
Enter global configuration mode.
Enable VTP version 2 on the switch.
VTP version 2 is disabled by default on VTP version 2-capable switches.
Return to privileged EXEC mode.
Verify that VTP version 2 is enabled in the VTP V2 Mode field of the display.
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
Configuring VTP
18-9. Use the no vtp transparent
"VTP Version" section on
18-13