Front Panel Of An Ex3300 Switch - Juniper EX3300 Complete Hardware Manual

Complete Hardware Guide for EX3300 Ethernet Switches
Table 4: Physical Specifications of the EX3300 Switch Chassis (continued)
Description
Weight
Related
Documentation

Front Panel of an EX3300 Switch

6
Rack Requirements for EX3300 Switches on page 63
Cabinet Requirements for EX3300 Switches on page 64
Mounting an EX3300 Switch on page 84
Installing and Connecting an EX3300 Switch on page 81
The front panel of an EX3300 switch consists of the following components:
Network ports:
Depending on the switch model, 24 or 48 10/100/1000BASE-T Gigabit Ethernet
ports (ports labeled 0 through 23 or 0 through 47)
Power over Ethernet Plus (PoE+) available in all network ports in EX3300-24P and
EX3300-48P models
Power over Ethernet Plus (PoE+) not available in any network port in EX3300-24T,
EX3300-24T-DC, EX3300-48T, and EX3300-48T-BF models
Four built-in uplink ports:
The uplink ports support 1-gigabit small form-factor pluggable (SFP) transceivers,
10-gigabit small form-factor pluggable (SFP+) transceivers, or a combination of
these transceivers.
Ports labeled 0 and 1 are, by default, configured as network ports. You can configure
these ports as Virtual Chassis ports (VCPs).
Ports labeled 2 and 3 are, by default, configured as VCPs. You can configure these
ports as network ports.
Network port and uplink port LEDs
Three chassis status LEDs
LCD panel and the LCD navigation buttons
Air intake or air exhaust, depending on the switch model—The intake or exhaust is
located immediately below the top edge of the front panel.
Value
EX3300-24T: 10 lb (4.6 kg)
EX3300-24P: 11.6 lb (5.3 kg)
EX3300-24T-DC: 9.8 lb (4.5 kg)
EX3300-48T: 10.8 lb (4.9 kg)
EX3300-48T-BF: 10.8 lb (4.9 kg)
EX3300-48P: 12.8 lb (5.8 kg)
Copyright © 2015, Juniper Networks, Inc.