Ex4200 Chassis; Front Panel Of An Ex4200 Switch - Juniper EX4200 Hardware Manual

NOTE: If you have a Juniper J-Care service contract, register any addition, change, or upgrade
of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
result in significant delays if you need replacement parts. This note does not apply if you replace
existing components with the same type of component.

EX4200 Chassis

IN THIS SECTION

Front Panel of an EX4200 Switch | 29

Rear Panel of an EX4200 Switch | 30
LCD Panel in EX4200 Switches | 31
Uplink Modules in EX4200 Switches | 33
Chassis Status LEDs in EX4200 Switches | 37
Management Port LEDs in EX4200 Switches | 39
Network Port LEDs in EX4200 Switches | 40
Front Panel of an EX4200 Switch
The front panel of an EX4200 switch consists of the following components:
Network ports—depending on the switch model, either:
10/100/1000Base-T Gigabit Ethernet ports, some or all of which are enabled for Power over Ethernet
(PoE)
100Base-FX/1000Base-X SFP ports for use with fiber-optic connections
Uplink module ports—SFP, SFP+, or XFP ports (Installing the uplink module is an optional.)
LCD panel and the LCD navigation buttons
. Failure to do so can
29