Installing Adjustable Mounting Brackets In A Rack Or Cabinet For An Ex8200 Switch - Juniper EX8208 Hardware Manual

You can install an EX8208 switch in a 19-in. equipment rack or cabinet by using the front-mounting bracket
attached to the chassis. To install the switch in a rack or cabinet, follow the instructions in
EX8208 Switch on a Rack or Cabinet Using a Mechanical Lift" on page 157
on a Rack or Cabinet Without Using a Mechanical Lift" on page
To connect an EX8208 switch to earth ground, follow instructions in
Series Switch" on page 164.
To connect power to the switch chassis, follow instructions in
on page 171.
To connect and configure the switch, follow instructions in
Switch (CLI Procedure)" on page 194
on page 198.
To connect the switch to a network for out-of-band management, follow instructions in
to a Network for Out-of-Band Management" on page
follow instructions in "Connect a Device to a Management Console Using an RJ-45 Connector" on page
Installing Adjustable Mounting Brackets in a Rack or Cabinet for an EX8200
Switch
To mount the switch on a four-post rack or cabinet, you must first install the adjustable mounting brackets
in the rack or cabinet. (The remainder of this topic uses "rack" to mean "rack or cabinet.") The EX8200
switch comes with a four-piece set of adjustable mounting brackets that supports the chassis in the rack.
NOTE: The adjustable mounting brackets are not for installation in two-post racks.
The four adjustable mounting bracket pieces are:
1 left front adjustable mounting bracket. The bracket is labeled "LEFT FRONT" on the side of the bracket
that faces the interior of the rack, near the holes for attaching the bracket to the rack.
1 right front adjustable mounting bracket. The bracket is labeled "RIGHT FRONT" on the side of the
bracket that faces the interior of the rack, near the holes for attaching the bracket to the rack.
2 rear adjustable mounting brackets. These brackets are labeled "REAR" on the side of the bracket that
faces the interior of the rack, near the holes for attaching the bracket to the rack. The rear brackets are
interchangeable; you can use either of the rear brackets with the right or left front adjustable mounting
bracket.
"Connecting and Configuring an EX Series
or "Connecting and Configuring an EX Series Switch (J-Web Procedure)"
182. To connect the switch to a management console,
or "Mounting an EX8208 Switch
159.
"Connect Earth Ground to an EX
"Connecting AC Power to an EX8200 Switch"
"Mounting an
"Connect a Device
183.
148