Table of Contents
Advertisement
Figure 5-3 shows the timing of the setting of the interrupt flags (IRQnF).
φ
IRQn
input pin
IRQnF
Note: n = 5 to 0
Interrupts IRQ
to IRQ
0
whether the corresponding pin is set for input or output. When using a pin for external interrupt
input, clear its DDR bit to 0 and do not use the pin for chip select output, refresh output, SCI
input/output, or A/D external trigger input.
5.3.2
Internal Interrupts
Thirty-Six internal interrupts are requested from the on-chip supporting modules.
• Each on-chip supporting module has status flags for indicating interrupt status, and enable bits
for enabling or disabling interrupts.
• Interrupt priority levels can be assigned in IPRA and IPRB.
• 16-bit timer, SCI, and A/D converter interrupt requests can activate the DMAC, in which case
no interrupt request is sent to the interrupt controller, and the I and UI bits are disregarded.
5.3.3
Interrupt Vector Table
Table 5-3 lists the interrupt sources, their vector addresses, and their default priority order. In the
default priority order, smaller vector numbers have higher priority. The priority of interrupts other
than NMI can be changed in IPRA and IPRB. The priority order after a reset is the default order
shown in table 5-3.
92
Figure 5-3 Timing of Setting of IRQnF
have vector numbers 12 to 17. These interrupts are detected regardless of
5
Advertisement
Table of Contents
