Table of Contents
Advertisement
Pin
P9
/TxD
1
1
P9
/TxD
0
0
8.7
Port A
8.7.1
Overview
Port A is an 8-bit input/output port that is also used for output (TP
timing pattern controller (TPC), input and output, (TIOCB
TIOCA
, TCLKD, TCLKC, TCLKB, TCLKA) by the 16-bit timer, input (TCLKD, TCLKC,
0
TCLKB, TCLKA) to the 8-bit timer, output (TEND
and address output (A
port, except that in modes 3 and 4, one pin is always used for A
the selection of pin functions.
Usage of pins for TPC, 16-bit timer, 8-bit timer, and DMAC input and output is described in the
sections on those modules. For output of address bits A
6.2.4, Bus Release Control Register (BRCR). Pins not assigned to any of these functions are
available for generic input/output. Figure 8.6 shows the pin configuration of port A.
Pins in port A can drive one TTL load and a 30-pF capacitive load. They can also drive a
darlington transistor pair. Port A has Schmitt-trigger inputs.
Pin Functions and Selection Method
Bit TE in SCR of SCI1, bit SMIF in SCMR, and bit P9
SMIF
TE
P9
DDR
1
Pin function
Note: * Functions as the TxD
driven, and another in which the pin is at high-impedance.
Bit TE in SCR of SCI0, bit SMIF in SCMR, and bit P9
SMIF
TE
P9
DDR
0
Pin function
Note: * Functions as the TxD
driven, and another in which the pin is at highimpedance.
to A
). A reset or hardware standby transition leaves port A as an input
23
20
DDR select the pin function as follows.
1
0
0
0
1
P9
input
P9
output
1
1
output pin, but there are two states: one in which the pin is
1
DDR select the pin function as follows.
0
0
0
0
1
P9
input
P9
output
0
0
output pin, but there are two states: one in which the pin is
0
, TIOCA
2
, TEND
) from the DMA controller (DMAC),
1
0
20
to A
in modes 3 and 4, see section
23
21
1
—
TxD
output
TxD
1
1
—
TxD
output
TxD
0
to TP
) from the programmable
7
0
, TIOCB
, TIOCA
2
1
output. See table 8.12 to 8.14 for
1
—
—
output*
1
1
—
—
output*
0
, TIOCB
,
1
0
261
Advertisement
Table of Contents
