Security Level - Agilent Technologies N9913A User Manual

2.
3.
4.
How to make Voltage Source settings
 Press System 7
 Then
 Then
 Then
 Then



Security Level

For security reasons, you can prevent frequency information from appearing on
the FieldFox while in SA, NA, or CAT modes.
How to set Security Level
 Press System 7
 Then
 Then
 Then choose from the following:
System Settings
Voltage setting from 1.00 V to 32.00 V with .01 V resolution.
Current: The amount of current (in Amperes) being drawn from the source.
Max Current: A conservative estimate of maximum current possible given
the present voltage setting. The actual 'trip' level may be slightly different.
System Configuration.
Voltage Source.
to enable and disable the voltage source output.
Source ON OFF
Using ▲|▼ arrows, the rotary knob, or numeric keypad,
Voltage x.xx V
enter a value between .001 and 32 volts.
If the voltage source becomes 'TRIPPED' press to re-enable
Clear Overload
the voltage source output. Then reset
Turn ON and OFF the voltage source status line that
Status Line ON OFF
appears near the top of the screen. The status line is always ON while making
Voltage Source settings.
System Configuration
Security Level
All frequency settings are visible.
None
o
Frequency information is blanked from the following:
High
o
o Display annotation
o Softkeys
o Marker display and marker table
o Calibration properties
o All settings tables
o Limit line tables
o All saved .png files
Any of the following will re-display frequency information:
o
o Set to None, Preset, Mode Preset, or FieldFox restart.
Source ON.
211