Problems While Running Applications - Intermec Trakker Antares 2400 User Manual

Chapter 4— Troubleshooting and Maintenance

Problems While Running Applications

Problems While Running Applications

Problem
The Connect LED blinks and you see this
message:
Unable to connect to
controller. Error 102.
Unable to establish
connection to host. Session
ended.
You see one of these error messages while
running a PSK or EZBuilder application:
SCREEN ERROR: 30
Code: 9
Hit any key To exit!
SCREEN ERROR: 31
Code: 3
Hit any key To exit!
You see this error message when trying to
load a program:
ERROR LOADING MODULE
LIBRARY NAME:
<libraryname>
FILENAME:
<filename>
where libraryname and filename are the
library and file names of the program.
A DOS command does not work.
You try to run a DOS application in the
TRAKKER Antares 2400 Menu System
and see this message:
Not a valid application.
The terminal does not boot after you
modified the CONFIG.SYS file to
configure a ROM-DOS drive.
68
nugget
If you are running applications on the terminal and have trouble, check
these possible problems and solutions.
Solution
The 2415 is connected to the access point, but is trying to establish
communications with the Intermec Gateway or DCS 30X and the host
computer. Make sure the terminal is correctly configured for your
network. In a UDP Plus or WTP network, make sure the Intermec
Gateway or DCS 30X is configured and data collection is started. In a
TCP/IP network, make sure the host computer is configured and
running.
If you have configured the network correctly, try shutting down and
restarting the Intermec Gateway or DCS 30X to establish
communications. You can also try resetting the terminal. For help
resetting the terminal, see "Booting and Resetting the Terminal" on
page 71.
You must set the RAM Drive Size configuration command. For help,
see "RAM Drive Size" in Chapter 6 of the 2400 Family system manual.
You need to free conventional memory by removing files or
applications from Drive C. For help, see "Delete File" in Chapter 5 of
the 2400 Family system manual.
The command is invalid. For a list of valid DOS commands, see
"Using ROM-DOS Commands" in Appendix D of the 2400 Family
system manual.
You tried to run a DOS .EXE application from the TRAKKER Antares
2400 Menu System. You can only run .BIN applications in the menu
system. To run a DOS .EXE application, enter the filename at the
DOS prompt. For help, see "Running DOS Applications and Using
ROM-DOS Commands" in Appendix D of the 2400 Family system
manual.
Correct the error in CONFIG.SYS and use the DOS software tools to
recreate Drive A with the corrected CONFIG.SYS file.
39 AGaramond
Trakker Antares 241X Handheld Terminal User's Manual