Making The Power Cable Connection; Network Setup; Configuring The Network - Stratasys Fortus 900mc User Manual

MAKING THE POWER CABLE CONNECTION

Warning: A licensed electrician must perform all wiring from service connect to
the transformer, and from the transformer to the system - including all connectors,
cables and proper strain relief.
This system requires a high voltage connection, which is made at the top right-hand corner at the back of the
system (Figure 3-2). High voltage is applied to the system using a Delta connection. The main breaker must be
off until a Stratasys authorized Service Technician has verified the connection. This system is only provided with
a Delta connection (Figure
Figure 3-3: Power Cable Connection

NETWORK SETUP

Your system is configured for your network as a part of its initial installation and setup. This section is provided in
case you have need to change your network settings.

CONFIGURING THE NETWORK

1. The network address can be Dynamic or Static.
• Dynamic address - a network server or PC will generate an IP address for the system. A different
IP address may be generated from time to time by the server or PC.
• Static address - you must enter an IP address, network mask, and gateway address for the
system (provided by the system administrator). Once entered, the address will not change.
2. In addition to configuring the IP address, you can set the UPnP configuration for the system.
• UPnP ON - the system will broadcast its (Unique Device Name) UDN address across the
network. This allows the Insight workstation software to automatically detect the IP address of
the system for communication.
• UPnP OFF - the system will not broadcast its IP address across the network. The Insight
workstation software will need to be manually configured to communicate with the system.
3-3).
High Voltage
Power Cable
Connection
27