Table of Contents
Advertisement
Changing Printer Defaults
Oven Temperature Control
Oven modeling temperature is determined by the material type (model and support) loaded
within the printer. It is controlled by the printer's software and cannot be modified; however, you
do have control of some oven temperature functions.
The Standby Mode setting gives the ability to put the printer into an energy saving state after
the completion of a build (see
selected (i.e. Standby Mode is turned On) the printer's oven will automatically shut off 2 hours
after the completion of a build, thus saving energy. When the Quick Start radio button is
selected (i.e. Standby Modes is turned Off) the printer's oven will remain On for 60 hours after
the completion of a build and oven temperature will stay at the material's build temperature.
To configure this setting, press anywhere within the Standby Mode row; the Standby Mode
page will be displayed. Use the radio buttons within this page to turn the Energy Saver option
On and Off.
Touchscreen Display Brightness
The Screen Brightness setting allows you to adjust the brightness of the touchscreen display
(see
"Screen Brightness" (page
approximately 80% brightness.
To configure this setting, press anywhere within the Screen Brightness row; the Screen
Brightness page will be displayed. Use the slider graphic to adjust brightness as needed;
sliding to the right will increase brightness, while sliding to the left will dim brightness. Please
note that you cannot set screen brightness to 0% (completely dim). After exiting the Screen
Brightness page the configured brightness will be displayed as a percentage within the Screen
Brightness row.
"Standby Mode" (page
Figure 28: Configure Standby Mode
78)). By default, the touchscreen display is configured to be at
Figure 29: Adjust Screen Brightness
© Copyright 2020 Stratasys. All rights reserved.
Oven Temperature Control
76)). When the Energy Saver option is
Page 123
Advertisement
Table of Contents
