Required Tools For Installing The Srx1400 Services Gateway Manually; Removing Components From The Chassis For Manual Lifting Of The Srx1400 Services Gateway - Juniper SRX1400 Hardware Manual

Related
Documentation

Required Tools for Installing the SRX1400 Services Gateway Manually

Related
Documentation

Removing Components from the Chassis for Manual Lifting of the SRX1400 Services Gateway

Copyright © 2011, Juniper Networks, Inc.
Lift the chassis into a rack. For more information, see "Lifting the SRX1400 Services
2.
Gateway Chassis into a Rack" on page 60.
Reinstall the components into the SRX1400 Services Gateway chassis. For more
3.
information, see "Reinstalling Components into the SRX1400 Services Gateway
Chassis" on page 62.
SRX1400 Services Gateway Safety Requirements, Warnings, and Guidelines on page 52
Required Tools for Installing the SRX1400 Services Gateway Manually on page 59
Installing the Mounting Hardware for the SRX1400 Services Gateway on page 54
Installing the SRX1400 Services Gateway in a Rack or Cabinet Manually on page 58
To install the device, you need the following tools and parts:
Phillips (+) screwdrivers, numbers 1 and 2
ESD grounding wrist strap
Removing Components from the Chassis for Manual Lifting of the SRX1400 Services
Gateway on page 59
Lifting the SRX1400 Services Gateway Chassis into a Rack on page 60
Reinstalling Components into the SRX1400 Services Gateway Chassis on page 62
To make the services gateway light enough to install manually, you must first remove
the following components from the chassis:
Power supplies
Fan tray
The procedure in this topic is for removing components from the base model of the
chassis for initial installation only. To use this procedure, you must have not yet connected
power cables to the services gateway.
To remove the components from the device:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis. For more information about ESD, see the
Gateway Hardware Documentation
Release each component by loosening its retaining screws and unlatching its ejector
2.
handles as appropriate.
Slide each component out of the chassis evenly so that it does not become stuck or
3.
damaged.
Chapter 5: Installing the SRX1400 Services Gateway
.
SRX1400 Services
59