Replacing The Cooling System Air Filter On The Srx1400 Services - Juniper SRX1400 Hardware Manual

SRX1400 Services Gateway Hardware Guide
Replacing the Cooling System Air Filter on the SRX1400 Services Gateway
118
Figure 34: Installing the Fan Tray into the SRX1400 Services Gateway
NOTE: Be sure the fan tray is correctly oriented in the slot, with the latch
on the bottom of the vertically aligned fan tray.
Press the fan tray into the chassis about 1 in. (2.5 cm) beyond where the latch closes
9.
to engage the power connection.
Reinsert the fan tray door, and close and tighten the captive screw to secure it in the
10.
chassis.
NOTE: The
FAN
that cooling system is operating normally.
CAUTION: Do not run the services gateway for more than a few minutes
without the air filter in place.
CAUTION: Always keep the air filter in place while the device is operating,
except during replacement. Because the fans are very powerful, they could
pull small bits of wire or other materials into the device through the unfiltered
air intake. This could damage the services gateway components.
NOTE: You can order an air filter kit separately. Contact your Juniper Networks
customer service representative for more information. The air filter kit includes
a cooling system air filter and four power supply air filters.
The services gateway cooling system has one air filter that installs in the rear of the
chassis. The air filter supports online insertion and removal.
LED on the System I/O card lights steadily green, indicating
Copyright © 2011, Juniper Networks, Inc.