Juniper SRX1400 Hardware Manual page 43

Copyright © 2011, Juniper Networks, Inc.
session setup based on policies, fast packet processing for packets that match a session,
encryption and decryption, and Internet Key Exchange (IKE) negotiation.
NOTE:
If an NSPC is not present, you must install a filler cover to shield the empty
slots 1 and 3 and to allow cooling air to circulate properly through the device.
You can either use an NSPC or combination of SRX3000 Series Services
Gateway Network Processing Card (NPC) and Services Processing Cards
(SPC), with a double wide tray holder on the SRX1400 Services Gateway
for the device to operate properly. For more details, see the "SRX3000
Series Services Gateway Cards Supported on SRX1400 Services Gateway"
on page 209.
The ONLINE button on NSPC does not perform any function and currently
it is not supported.
Figure 8 on page 23 shows the SRX1400 Services Gateway NSPC.
Figure 8: SRX1400 Services Gateway Network and Services Processing
Card
Table 17 on page 23 describes the NSPC behavior indicated by the LEDs on its front panel.
Table 17: SRX1400 Services Gateway Network and Services Processing
Card LED Indicators
Label Color
Green
SERVICE
Amber
Red
Dark (unlit)
Chapter 2: SRX1400 Services Gateway Hardware Components
Status Description
On steadily The NSPC is running under
acceptable load.
On steadily The NSPC is overloaded.
On steadily No service is being provided
by the NSPC.
Off The NSPC is not enabled.
23