Lifting The Srx1400 Services Gateway Chassis Into A Rack - Juniper SRX1400 Hardware Manual

SRX1400 Services Gateway Hardware Guide
Related
Documentation

Lifting the SRX1400 Services Gateway Chassis into a Rack

60
Label each component as you remove it so you can reinstall it in the correct location.
4.
Immediately store each removed component in an electrostatic bag.
5.
Do not stack removed components. Set each one on a flat surface.
6.
Required Tools for Installing the SRX1400 Services Gateway Manually on page 59
Lifting the SRX1400 Services Gateway Chassis into a Rack on page 60
Reinstalling Components into the SRX1400 Services Gateway Chassis on page 62
Lifting the chassis and mounting it in a rack requires two people (see Figure 22 on page 60).
Without the power supply and fan tray, the chassis weighs approximately 23.3 lb (10.57
kg).
Ensure that the rack is in its permanent location and is secured to the building.
1.
Position the chassis in front of the rack.
2.
With one person on each side, lift the chassis into position in the rack.
3.
WARNING: Do not attempt to lift the chassis by the handles on the power
supplies or on the CFMs. The handles might break off, causing the chassis
to fall and inflict injury.
Figure 22: Lift the Chassis Into the Rack
Align the bottom hole in each mounting bracket with a hole in each rack rail as shown
4.
in Figure 23 on page 61.
Copyright © 2011, Juniper Networks, Inc.