Performing Initial Software Configuration On The Srx1400 Services Gateway (Cli Procedure) - Juniper SRX1400 Hardware Manual

SRX1400 Services Gateway Hardware Guide
Related
Documentation
Performing Initial Software Configuration on the SRX1400 Services Gateway (CLI
Procedure)
86
Gather the following information before configuring the device:
Name the device will use on the network
Domain name the device will use
IP address and prefix length information for the Ethernet interface
IP address of a default router
IP address of a DNS server
Password for the root user
Connecting the SRX1400 Services Gateway to a Network for Out-of-Band Management
on page 73
Connecting the SRX1400 Services Gateway to a Management Console or an Auxiliary
Device on page 74
Performing Initial Software Configuration on the SRX1400 Services Gateway (CLI
Procedure) on page 86
This sample procedure explains how you can create an initial configuration using CLI
commands to connect the services gateway to the network. For complete information
about enabling the device to forward traffic, including examples, see the appropriate
Junos OS configuration guides.
To configure Junos OS:
Verify that the device is powered on.
1.
Log in as the root user. There is no password.
2.
Start the CLI.
3.
root#cli
root#
Enter configuration mode.
4.
configure
[edit]
root@#
Copyright © 2011, Juniper Networks, Inc.