Connecting The Srx1400 Services Gateway To A Management Console Or An Auxiliary Device - Juniper SRX1400 Hardware Manual

SRX1400 Services Gateway Hardware Guide
Related
Documentation

Connecting the SRX1400 Services Gateway to a Management Console or an Auxiliary Device

74
Figure 28: Ethernet Cable Connector
Plug the other end of the cable into the management device.
2.
Proceed with grounding and powering on the device.
3.
Connecting the SRX1400 Services Gateway to a Management Console or an Auxiliary
Device on page 74
SRX1400 Services Gateway Software Configuration Overview on page 85
Performing Initial Software Configuration on the SRX1400 Services Gateway (CLI
Procedure) on page 86
To use a system console to configure and manage the Routing Engine, connect it to one
of the ports on the SYSIOC, using the RJ-45 cable.
CONSOLE
To connect a management console or an auxiliary device:
Plug the RJ-45 end of the cable (see Figure 29 on page 75) into one of the
1.
ports on the SYSIOC.
CONSOLE
Copyright © 2011, Juniper Networks, Inc.