Juniper SRX1400 Hardware Manual page 92

SRX1400 Services Gateway Hardware Guide
Related
Documentation
72
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Insert the appropriate cables into the cable connector ports on each IOC. Secure the
8.
cables so that they are not supporting their own weight. Place excess cable out of the
way in a neatly coiled loop. Placing fasteners on a loop helps to maintain its shape.
CAUTION: Do not let the fiber-optic cable hang free from the connector.
Do not allow fastened loops of cable to dangle, which stresses the cable
at the fastening point.
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
You can proceed with installing other hardware components, or power supplies, or
connecting to a management device. See "Powering On the SRX1400 Services Gateway"
on page 82 to power on the SRX1400 Services Gateway.
WARNING: Never lift the services gateway using the handles on the front
panels of the IOCs or other CFM cards. The handles might come off, causing
the chassis to drop and inflicting possible grave injury.
16-Port SFP Gigabit Ethernet I/O Card on page 29
2-Port XFP 10-Gigabit Ethernet I/O Card on page 31
Installing an I/O Card with Copper Media Interfaces in an SRX1400 Services Gateway
on page 69
SRX1400 Services Gateway Hardware Components on page 13
Copyright © 2011, Juniper Networks, Inc.